Kawasaki KLX300 Tuned Velocity Stack
Unleash some hidden performance from your KLX engine! Engineered and developed specifically for the KLX300 series of motorcycles. The stock Kawasaki airbox naturally has some internal surfaces and shapes that disrupt air flow as it exits towards the intake plenum and into the throttle body. This results in uneven and limited air flow - reducing the full potential power output.
This velocity stack is designed to align the maximum possible volume of smooth air directly into the throttle body. Typically, this mod will allow for a 3% increase in power with slightly better throttle response as well. This velocity stack is used and recommended by the HyperLite Crew!
This product fits the following Kawasaki motorcycles:
2020+ KLX300R
2021+ KLX300 dual sport
2021+ KLX300 super moto
Important! - Installation of this product requires the application of fuel/oil resistant RTV Silicone Rubber, which is not included with this product. Most auto parts stores carry it - a small tube will be plenty.
Actual product color may vary depending on production availability, coming in Red and also Blue as shown.
Running this product alone without any other mods should not require the use of an EJK Tuner.
For maximum intake performance - we recommend combining this product with our KLX300 Air Filter Holder and also our KLX300 Hi-Flo Intake Lid.
Note - The stock airbox assembly will need to be removed from the bike and disassembled, in order to properly install this velocity stack. After the airbox is opened up and the air filter holder is removed (4 screws) then you can install the velocity stack, which simply slides into place. Before installing - make sure to thoroughly clean and degrease the inner area of the airbox and also the backside of the velocity stack. You will need to coat well the outside area of the small end of the velocity stack with silicone sealant. We also strongly recommend a good coating of silicone sealant along the flat backside of the velocity stack where it sets against the inside wall of the airbox, to help keep the funnel secure. Allow silicone to dry a minimum of 24-48 hours prior to reassembly and running the bike.